Author: kartik_subbarao
Subject: Z270 Supercarrier 09/d0, can't go to backup BIOS
Posted: 23 Feb 2017 at 12:25am
I have a Z270 Supercarrier and used the Internet Flash utility in UEFI setup to upgrade the BIOS from 1.10 to 1.11. The upgrade process completed successfully and no errors were reported. However, when the computer rebooted with the new BIOS, it just hung with a blackscreen. I have rebooted the system over 20 times, with the same result. The boot process runs for about 15 seconds, the Dr. Debug LED settles on 09 or d0, and remains in that hung state.
Subject: Z270 Supercarrier 09/d0, can't go to backup BIOS
Posted: 23 Feb 2017 at 12:25am
I have a Z270 Supercarrier and used the Internet Flash utility in UEFI setup to upgrade the BIOS from 1.10 to 1.11. The upgrade process completed successfully and no errors were reported. However, when the computer rebooted with the new BIOS, it just hung with a blackscreen. I have rebooted the system over 20 times, with the same result. The boot process runs for about 15 seconds, the Dr. Debug LED settles on 09 or d0, and remains in that hung state.
According to the manual, "after several failed boot attempts, the backup BIOS will take over" -- but this doesn't seem to be happening. It still boots from the active BIOS (BIOS_A_LED is on). I also tried unplugging the computer and depressing the clear CMOS button for over 10 seconds, but that didn't seem to have any affect.
Is there any way that I can force a switch to BIOS B, or alternatively, downgrade BIOS A back to 1.10? The motherboard was working fine with 1.10 before I upgraded it to 1.11.