Author: batch
Subject: Z170 Extreme6 - debug code 99
Posted: 07 Feb 2017 at 4:03am
Hi,
I tested this some days before. I tried 2 pieces to get dual channel, I tried 1 piece in A1, in B1.. always with the same result.
I know that there is no official support for my RAMs. But why there's no fault until BIOS v1.2 ?
Maybe I'm wrong with this.. but if the board would have problems with the RAMs, the codes 0d or b0 should displayed .. -> http://asrock.com/support/faq.asp?id=334
Edited by batch - 3 hours 7 minutes ago at 4:04am
Subject: Z170 Extreme6 - debug code 99
Posted: 07 Feb 2017 at 4:03am
 wardog wrote:After re-reading your posts......... Reset the BIOS, then .. using only two of the Ripjaws4 sticks in A2 and B2 slots, boot, go into the BIOS and set them up manually, not via XMP. 3200 16-16-16-36-2N(CR) 1.35v If that fails move them to A1 and B1, reset the BIOS, boot, go into the BIOS and set them up manually, not via XMP. 3200 16-16-16-36-2N(CR) 1.35v Post back your results of those two tests would you please. |
Hi,
I tested this some days before. I tried 2 pieces to get dual channel, I tried 1 piece in A1, in B1.. always with the same result.
I know that there is no official support for my RAMs. But why there's no fault until BIOS v1.2 ?
Maybe I'm wrong with this.. but if the board would have problems with the RAMs, the codes 0d or b0 should displayed .. -> http://asrock.com/support/faq.asp?id=334
Edited by batch - 3 hours 7 minutes ago at 4:04am